Zebra TTPM2 Wartungshandbuch

Publ No.: 00861-000 Ed. A October 3, 2001 TTPM2 Ticket Printer/Encoder Operators’ Guide SW95045

10 TTPM2 Operators’ Guide October, 01 3.2 Weekly (performed by trained operator or handyman) This should be carried out Weekly in high print-volum

October, 01 TTPM2 Operators’ Guide 11 Figure 9. Blow the dust from the sensors. • Raise the lid, and using the air duster, point the nozzle at

12 TTPM2 Operators’ Guide October, 01 Next clean the roller attached to the brass gear used above: • Turn the printer off, open the lid, and lift

October, 01 TTPM2 Operators’ Guide 13 3.3 Annual (performed by technician)  Disconnect the power and interface cable.  Remove the cover.  C

14 TTPM2 Operators’ Guide October, 01 4 FAULTFINDING 4.1 No tickets produced and yellow indicator ON Load ticket stock in the selected ticket trac

October, 01 TTPM2 Operators’ Guide 15 4.4 Many encoding retries  Bad stripe material on ticket.  Wrong ticket thickness.  The ticket materi

16 TTPM2 Operators’ Guide October, 01 4.7 Messages on your screen The printer communicates with the host computer that runs your ticket booking so

October, 01 TTPM2 Operators’ Guide 17 4.8 Indicators on the printer Different error types can show up during processing. The most common is that

18 TTPM2 Operators’ Guide October, 01 5 CORRECTIVE ACTIONS 5.1 General reset A general reset of the TTPM2, restoring all parameters to their defaul

October, 01 TTPM2 Operators’ Guide 19 5.2.6 Lifting the printhead Push the printhead release lever forward while lifting the printhead. Release t

2 TTPM2 Operators’ Guide October, 01 Related manuals TTPM2 Selection Guide, 101193 TTPM2 Operators’ Guide, 00861-000 TTPM2 Technical Specificatio

20 TTPM2 Operators’ Guide October, 01 6 MOVING THE PRINTER If you plan to move the printer follow the steps below to avoid unpleasant surprises. 6

October, 01 TTPM2 Operators’ Guide 21 6.3 Ensure interference free environment The new location must be without electrical and magnetical interfe

22 TTPM2 Operators’ Guide October, 01 7 TICKET STOCK The TTPM2 printers are produced, calibrated for, and tested with the customers ticket stock. W

October, 01 TTPM2 Operators’ Guide 3 CONTENTS 1 Introduction ...

4 TTPM2 Operators’ Guide October, 01 1 INTRODUCTION This manual should help you maintain your printer in top condition over many years and hundreds

October, 01 TTPM2 Operators’ Guide 5 2 OPERATION 2.1 Switching on The power switch is on the rear right side of the printer. Do not press any othe

6 TTPM2 Operators’ Guide October, 01 2.2 Operator controls The front panel has three buttons and three indicators with the following functions. Gre

October, 01 TTPM2 Operators’ Guide 7 2.3 Loading tickets NOTE! – Do not turn off the printer to load tickets. 2.3.1 Single and dual track version

8 TTPM2 Operators’ Guide October, 01 2.3.2 CD 200 version  Load the tickets in the hopper with the magnetic stripe facing down and the railway s

October, 01 TTPM2 Operators’ Guide 9 3 MAINTENANCE 3.1 Daily (performed by operator) This should be carried out Daily in high print-volume enviro