Zebra Z4Mplus Bedienungsanleitung PDF herunterladen (Seite 103)

Configuration

Configuration and Calibration Sequence

Z4Mplus and Z6Mplus User Guide 73

PROTOCOL Press SELECT to make change.

Setting Protocol: Press PLUS (+) or MINUS (–) to display

other choices.

Default: None

Selections: None, Zebra, ACK_NACK

Press SELECT to accept the change.

Protocol is a type of error checking system. Depending on

the selection, an indicator may be sent from the printer to the

host computer signifying that data has been received. Select

the protocol that is requested by the host computer. Further

details on protocol can be found in the ZPL II Programming

Guide Volume I.

Zebra is the same as ACK_NACK except that with Zebra the

response messages are sequenced.

If Zebra is selected, printer must use DTR/DSR host

handshake protocol.

NETWORK ID Press SELECT to make change.

Setting Network ID: Press MINUS (–) to move to the next

digit position, press PLUS (+) to increase the value of the

digit.

Default: 000

Range: 000 to 999

Press SELECT to accept the change.

Network ID is used to assign a unique number to a printer

used in an RS-422/RS-485 network. This gives the host

computer the means to address a specific printer. If the

printer is used in a network, you must select a network ID

number. This does not affect TCP/IP or IPX networks.

Display Shows Action/Explanation

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 177 178

Keine Kommentare

Zebra Z4Mplus Bedienungsanleitung Seite 103