Zebra GC420t Betriebsanweisung PDF herunterladen (Seite 30)

Loading Transfer Ribbon

P1039498-001 GC420t™ User Guide 8/15/2011

6. If printer power is on, press the Feed button to have the printer feed a minimum of 10 cm

(4 inches) of media to remove slack and ribbon wrinkle, and to align the ribbon on the

spindles. Otherwise, wait to turn on the printer and complete the printer ‘Getting Started’

instructions in this chapter.

7. Change the print mode setting from direct thermal printing to thermal transfer to set the

printer’s temperature profiles for thermal transfer media. This can be done with the printer

driver, application software, or printer programming commands.

• When controlling printer operations with ZPL programming, refer to the Media Type

(^MT) ZPL II command (follow the instructions in the ZPL Programming Guide).

• When controlling printer operations with EPL Page Mode, refer to the Options (O)

EPL command (follow the instructions in the EPL Page Mode Programmer’s Guide).

8. To verify the mode change from direct thermal printing to thermal transfer printing, use

the Printing a Test (Printer Configuration) Label on page 19 to print a configuration label.

The ‘PRINT METHOD’ should read ‘THERMAL-TRANS’ on the printer configuration

status label.

Your printer is now ready to print.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 115 116

Keine Kommentare

Zebra GC420t Betriebsanweisung Seite 30