Zebra S600 Spezifikationen PDF herunterladen (Seite 42)

Page 2-12 S400/S600 Maintenance Manual 44895L Rev. 3 3/12/04

6HFWLRQ 2SHUDWLRQV2YHUYLHZ

5LEERQ/RDGLQJ

$GMXVWLQJWKH5LEERQ6XSSO\6SLQGOH

The S400/S600 comes with a dual-tension ribbon supply spindle to provide the

appropriate amount of tension on the ribbon.

Normal Position

Refer to Figure 2-9. In the normal position, the dual-tension ribbon supply spindle

provides the desired amount of ribbon back-tension for different ribbon widths. To place

the spindle in the normal position, firmly pull the spindle end-cap until it clicks into place.

Low-Tension Position

The low-tension position is used in limited applications with ribbons wider than 2.4 in.

(61 mm) to provide lower back-tension. The low-tension position is recommended only

when normal tension hampers ribbon movement. To place the spindle in the low-tension

position, firmly push the spindle end-cap until it clicks into place.

Note • Do not load ribbon if the printer is to be used in direct thermal mode.

Caution:

Do not use ribbon that is narrower than the media. Premature printhead failure may

result due to excessive abrasion caused by thermal transfer media.

Figure 2-9. Dual-Tension Ribbon Supply Spindle Adjustment

Spindle End-Cap

Extended (normal)

Blades Aligned

Spindle End-Cap

Retracted (low-tension)

Align blades if ribbon width is greater than 2.4 in. (61 mm).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 167 168

Keine Kommentare

Zebra S600 Spezifikationen Seite 42