Zebra ZD500 Betriebsanweisung PDF herunterladen (Seite 112)

Printer Options

Label Dispenser Option

100

P1062653-002 Rev. A ZD500 Series™ Thermal Transfer Printer User’s Guide 1/16/2014

Label Dispenser Option

The factory installed label dispenser option allows you to print a label with backing

(liner/web) being removed from the label as it prints, ready for application. When printing

multiple labels, removing the dispensed (peeled) label notifies the printer to print and dispense

the next label.

To use dispenser-mode correctly, use your printer driver to activate the label (taken) sensor

along with these typical label settings which include but are not limited to length, non-

continuous (gap), and web (liner). Otherwise, you must send the ZPL programming

commands to the printer.

When programming in ZPL, you can use the following command sequences shown below

and refer to your ZPL Programming Guide for more information on ZPL programming.

^XA ^MMP ^XZ

^XA ^JUS ^XZ

1. Load your labels into the printer. Close the printer and press the Feed button until a

minimum of 4 inches or 100 millimeters of exposed labels exit the printer. Remove the

exposed labels from the liner.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 159 160

Keine Kommentare

Zebra ZD500 Betriebsanweisung Seite 112