Zebra 170PAX2 Series Betriebsanweisung PDF herunterladen (Seite 27)

MAXIMUM LENGTH Setting Maximum Length Press the RIGHT BLACK OVAL key to increase

the value, press the LEFT BLACK OVAL key to decrease the value.

Default: 39.0” (988 mm)

Range: 2.0” (50 mm) to 39.0” (988 mm) in 1.0” (25.4 mm) increments

Maximum length is used in conjunction with the calibration procedure. The

value of this setting determines the maximum label length that will be used dur-

ing the media portion of the calibration process. The maximum length is the dis-

tance from the leading edge of one label to the leading edge of the next label.

The interlabel gap is considered part of the label length.

Only a few labels are required to set media sensors. Always set the value that is

closest to, but not lower than, the length of the label you are using. For example,

if the length of the label is 14.5 inches (368 mm), set the parameter for 15.0

inches (381 mm).

LIST FONTS List Fonts Press the RIGHT BLACK OVAL key to print a label listing all of the

available fonts.

This selection is used to print a label that lists all of the fonts currently available

in the print engine, including standard print engine fonts plus any optional fonts.

Fonts may be stored in RAM, FLASH memory, font EPROMS, or font cards.

LIST BAR CODES List Bar Codes Press the RIGHT BLACK OVAL key to print a label listing all

of the available bar codes.

This selection is used to print a label that lists all of the bar codes currently

available in the print engine

LIST IMAGES List Images Press the RIGHT BLACK OVAL key to print a label listing all of

the available images.

This selection is used to print a label that lists all of the images currently stored

in the print engine’s RAM, FLASH memory, optional EPROMS, or font cards.

LIST FORMATS List Formats Press the RIGHT BLACK OVAL key to print a label listing all of

the available formats.

This selection is used to print a label that lists all of the formats currently stored

in the print engine’s RAM, FLASH memory, optional EPROMS, or font cards.

LIST SETUP List Images Press the RIGHT BLACK OVAL key to print a label listing the

current print engine configuration.

This selection is used to print a label that lists the current print engine configura-

tion. (Same as CANCEL key self test.)

LIST ALL List Images Press the RIGHT BLACK OVAL key to print a label listing all of

the available fonts, bar codes, images, formats, and the current print engine con-

figuration.

This selection is used to print a label that lists the five previous selections as

described.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 99 100

Keine Kommentare

Zebra 170PAX2 Series Betriebsanweisung Seite 27