Zebra T5206R Bedienungsanleitung PDF herunterladen (Seite 110)

110

Chapter 3 QUICK SETUP

The allowable Label Length range is 00.1 to 99.0 inches (2.5 - 2514.6mm)

The factory defaults are listed below:

Maximum Label Length range is dependent on the Label Width value

selected, printhead installed (203 or 300 DPI). See Appendix A for

specifications.

NOTE: See “Set Label Length” on page 134.

Label Width

This option specifies the physical width of the image to be printed. The value

can be specified in inches or millimeters depending on the setting of the Units

submenu under the MEDIA CONTROL menu. The allowable range in inches

is 00.1 to the maximum print width of the printer. The allowable range in

millimeters is 2.5 to the maximum width of the printer.

Ver Image Shift

This option specifies the amount to shift an image vertically up (-) or down (+)

for precise positioning on the label. The actual height of the image is not

affected by this parameter. The allowable range is -1.00 inches to the current

Label Length value setting, up to a maximum of 12.80 inches, in .01 inch

increments.

The factory default value is 0.00 inches.

Hor Image Shift

This option specifies the amount to shift an image horizontally left (-) or right

(+) for precise positioning on the label. The actual width of the image is not

affected by this parameter. The allowable range is -1.00 to +1.00 inches in .01

inch increments.

The factory default value is 0.00 inches.

Table 2. Factory Default Label Length

Printer

Inches mm Lines

T5X04

6 152.4 36

T5X06

4 101.6 24

T5X08

6 152.4 36

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 393 394

Keine Kommentare

Zebra T5206R Bedienungsanleitung Seite 110