Zebra ZP 450 Betriebsanweisung PDF herunterladen (Seite 30)

Getting Started

Adjusting the Print Width

980546-003 B ZP 450™ User Guide 12/17/07

Adjusting the Print Width

Print width must be set when:

• You are using the printer for the first time.

• There is a change in media width.

Print width may be set by:

• The Windows printer driver or application software such as Zebra Designer.

• The five-flash sequence in Feed Button Modes on page 53.

• Controlling printer operations with ZPL programming; refer to the Print Width (^PW)

command (consult your ZPL Programming Guide).

Controlling printer operations with EPL Page Mode programming, refer to the Set Label

Width (

q) command (consult your EPL Programmer’s Guide).

Adjusting the Print Quality

Print quality is influenced by the heat of the printhead, the speed of the media and the type of

media you are using. Only by experimenting will you find the optimal mix for your

application.

The relative darkness (or density) setting can be controlled by:

• The six-flash sequence in Feed Button Modes on page 53. This will overwrite any ZPL

and EPL programmed darkness/density settings.

• The Set Darkness (

~SD) ZPL command (consult your ZPL Programming Guide).

• The Density (D) EPL command (consult your EPL Programmer’s Guide).

If you find that the print speed needs to be adjusted, use:

• The Windows printer driver.

• The Print Rate (^PR) command (consult your ZPL Programming Guide).

The Speed Select (

S) command (consult your EPL Programmer’s Guide).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 69 70

Keine Kommentare

Zebra ZP 450 Betriebsanweisung Seite 30