Zebra 2746e Wartungshandbuch PDF herunterladen (Seite 22)

18 980428-103 Rev. 1 Prelim.

Add Cable

Anchor Ties

Installation

1. Reverse the power supply removal and

access processes.

-- If replacing the power supply, the AC

voltage should be set prior to installing the

power supply, see procedure 980428-104.

-- The DC voltage setting should be verified

prior to attaching the power supply to the

printer, see procedure 980428-105.

Important - Re-attach the ground wire to

the power supply in the following order:

1) Star Washer 2) Ground wire and lug

(from toroid) 3) Star Washer 4) Nut.

Tighten the nut to 7.5 ±2 in. Lb. torque

2. Add two (2) cable tie anchors to the front

and rear of the power supply (as shown).

3. Re-tie the main PCBA harness. Use the

"Securing the Harness" procedure,

980428-009.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare