Zebra 2746e Wartungshandbuch PDF herunterladen (Seite 38)

34 980428-116 Rev. 1 Prelim.

5. Align the printhead with the two bracket

alignment pins.

6. Secure printhead to printhead bracket by

tightening the printhead bracket Allen head

screw. Tighten the screw to 4.7 ±1 in. lb.

7. Close and open the printhead and recheck

that the printhead cable still secure and

connected to the printhead. Verify that 1/4

is inside and 3/4 of the spiral wrap is outside

of the center panel. This protects the cable

from rubbing on the belt and printhead

carriage.

8. Re-tie the main PCBA harness. Use the

"Securing the Harness" procedure

980428-009.

9. Clean the printhead after completing

installation.

Pin 1 of JP21

printhead

Connector

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare