Zebra TTP2130 Spezifikationen PDF herunterladen (Seite 61)

Programming

Software Command Syntax

09/28/2009 TTP 2100 Technical Manual P1003640-002

Prints a dotted line, a pair of scissors, and partially cuts the paper from both edges towards the

center to make it easier to tear off the paper. This command causes all data in the image buffer

to be printed and generates the printout of a fixed page when n36 = 0.

The length of the partial cut can be set with parameter n60. Refer to Partial Cut Length

on page 94 for more information.

ESC FF ejects the document through the presenter module. Variable n1 represents the eject-

length in millimeters. The setting of parameter n47 is always added to the value of n1.

The valid range for n is 1 to 127. The range 128-255 is reserved for future use.

Place this command after a cut command (ESC RS) to partially eject the printout to the

customer. Set the eject length so that the customer sees that the printout comes out of the kiosk

wall. The pull detector gives motorized eject of the rest of the printout when the customer

begins to pull the paper.

EM n1 functions the same as ENQ but overrides the Retract and Retain parameter (n45) with

another presenter behavior. The valid range of n1 is 0 to 255. Values of 0 - 99 cause the printer

to eject the paper as with ENQ. Values of 100 - 255 cause paper retraction. The command will

clear the presenter immediately (with printing synchronization).

Partial Cut (Unit Separate)

1F hex

031 decimal

ESC FF n1

Eject (Run Presenter)

1B 0C n1 hex

27 12 n1 decimal

Note • The cut and eject command RS, automatically ejects 50 mm in addition to the amount

stored in parameter n47.

EM n1

Enforced Clear Presenter

19 n1 Hex

25 n1 Decimal

<EM><0> Ejects the presented page

Retracts the presented page

Kiosk

wall

n47

Eject n

Printer

Eject 1 mm

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 131 132

Keine Kommentare

Zebra TTP2130 Spezifikationen Seite 61