Zebra TTPM3 Spezifikationen PDF herunterladen (Seite 41)

Programming

Command Reference

01/06/2009 TTPM3 Installation and Programming Manual P1003642-001

• Eject Fully

Adding an E (!PE) makes the printer eject the ticket fully so that it can fall down into a

tray (for FL3 printers)

Digits and @, or digits and E can be mixed on the same line, for example !P5@ makes

five encoding retries, and ejects the ticket into the wastebasket.

!Q writes a string with up to 15 ASCII characters to a non-volatile buffer memory in the

printer.

After the ticket has been correctly encoded / printed, the string is copied to a non-volatile

buffer. This buffer can be read by the !V-command.

The transaction string is committed at the precise point where a useable ticket has been

produced. The only way to reset a transaction string is to successfully print another useable

ticket that was initiated with !Q.

The TTPM3 responds by sending two bytes to the host computer. Byte 1 indicates the status of

the various TTPM3 sensors according to the following table. Byte 2 reports the temperature of

the thermal print head and is only used internally in the TTPM3.

See also: ENQ on page 43.

Write transaction string

21 51 n1...n15 Hex

33 81 n1...n15 Decimal

Example • !Q asdfgh <CR><LF>

Status request

21 53 Hex

33 83 Decimal

Bit Function Sensor Value ”1” Value ”0”

0 Lower rear document entry J6 Paper present No paper

1 Upper rear document entry J7 Paper present No paper

2 Top-of-form J8 Paper present No paper

3 Cutter position J9 Paper present No paper

4 After cutter position J10 Paper present No paper

5 Cutter J21 Cutter home Cutter not home

On CD200 versions with “card level low” sensor, this bit indicates low card level.

(printer version 02441-002, 5600-A0015)

6 Print head – OK Error

7 Front Load Sensor J11 Paper present No paper

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 111 112

Keine Kommentare

Zebra TTPM3 Spezifikationen Seite 41