Zebra ZXP Series 7 Bedienungsanleitung PDF herunterladen (Seite 80)

76 Zebra ZXP Series 3 Card Printer User’s Manual P1058486-002

6: Troubleshooting

Troubleshooting Procedures

MECHANICAL ERROR

(continued)

The card feeder feeds two cards

completely onto the feeder.

The card feeder partially feeds the

second card, thereby blocking flipper

operation.

The card feeder does not feed a card.

This may be because two cards are

stuck together or a leading edge

is damaged.

The card feeder does not feed a card;

and it is not due to stuck-together

cards, damaged cards, or cards that

were not fanned.

Calibrate the Card Load Sensor via

the !SAP 1 command. For command

implementation, refer to Tools on

page 49.

The card thickness adjustment

(arrow below) should be closed one

or two clicks, one click at a time.

Remove the card, fan the card stack,

and return the cards to the

card feeder.

The card thickness adjustment

(arrow below) should be opened one

or two clicks, one click at a time.

OUT OF CARDS Check for cards in the card feeder.

Card did not feed.

If no cards present, load cards; then

press the Panel Button for 1 second.

The printing job will restart.

1. Verify that the card thickness

adjustment (arrow below) is set to

the thickness of the cards being used.

2. Fan the card stack to ensure that

cards are not stuck together.

3. Remove the first card in the stack,

and check if the edge is damaged;

discard if it is.

4. Open the card thickness

adjustment one or two detent clicks.

ERROR MESSAGES (printer will not operate)

Problem / Symptom Description or Cause Possible Solution

Note

Note: If the problem persists, contact Technical Support; see Worldwide Support on page 127.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 133 134

Kommentare zu diesen Handbüchern

Keine Kommentare

Zebra ZXP Series 7 Bedienungsanleitung Seite 80

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucken & Scannen Zebra ZXP Series 7