Zebra 96XiIII Plus Spezifikationen PDF herunterladen (Seite 18)

3. Lift the Upper Media Sensor assembly and

move the sensor and the wire cover to the

outside half. Carefully pull the wires through

the tie wrap. You may need to set aside the

sensor wire cover if the adjustment is far to the

outside.

4. Replace and tighten the Phillips head screw.

5. Make sure the wires are routed back into the

groove of the media sensor bracket.

Lower Media Sensor Adjustment

1. Locate the Lower Media Sensor Assembly

(Figure 13-A) under the rear idler roller. (It is a

spring clip holding a circuit board.)

2. Slide the sensor until the two brass-colored

infrared emitters are under the Upper Media

Sensor. Gently pull wires out as needed (wires

should have a little slack).

Note: If the sensor is being moved inward and a

large loop of wire develops, remove the

cover from the electronics side of the

printer and gently pull the wires through.

Clamp the wires so that they do not rub

any drive belts.

90 English

Figure 13

E:\jobs\EH91 Zebra\XiIII\XiIII-gb.vp

Wednesday, December 15, 1999 8:59:13 AM

Color profile: Disabled

Composite Default screen

1 2 ... 13 14 15 16 17 18

Keine Kommentare

Zebra 96XiIII Plus Spezifikationen Seite 18