Zebra Z6Mplus Betriebsanweisung PDF herunterladen (Seite 118)

Routine Maintenance

Cleaning Procedures

110

13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06

Clean the Cutter Module

If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter.

To clean the cutter module, complete these steps:

1. Turn the printer Off (O), and unplug the printer from its power source.

Remove the cutter shield by removing the cutter shield thumbscrew and lock washer.

3. See Figure 35. Using the Preventive Maintenance Kit (part number 47362) or a solution of

90% Isopropyl and 10% deionized water and swab, wipe along the upper cutting surface.

Allow the solvent to evaporate.

Figure 35 • Cleaning the Cutter Module

4. To expose the V-shaped cutter blade, turn the cutter motor thumbscrew counterclockwise

to lower the blade.

5. Using the Preventive Maintenance Kit (part number 47362) or a solution of 90%

Isopropyl and 10% deionized water and swab, wipe along the cutter blade. Allow the

solvent to evaporate.

Caution • For personnel safety, always power off and unplug the printer before performing

this procedure.

Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.

Cutter shield

Cutter shield thumbscrew and lock washer

Upper cutting surface

Cutter blade

Cutter motor thumbscrew

123

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 165 166

Keine Kommentare

Zebra Z6Mplus Betriebsanweisung Seite 118