Zebra Z6Mplus Betriebsanweisung PDF herunterladen (Seite 98)

Configuration

Control Panel LCD Displays

13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06

Select ZPL Mode

The printer remains in the selected mode until it is changed by this

parameter or by using a ZPL/ZPL II command. The printer accepts label

formats written in either ZPL or ZPL II, eliminating the need to rewrite any

ZPL formats that already exist. See the ZPL II Programming Guide for

more information on the differences between ZPL and ZPL II.

Default: ZPL II

Selections: ZPL II, ZPL

To change the value shown:

1. Press SELECT to select the parameter.

2. Press

PLUS (+) or MINUS (-) to toggle between the options.

3. Press

SELECT to accept any changes and deselect the parameter.

Select Media Power-Up Option

This parameter sets the action of the media when you turn on the printer.

Default: CALIBRATION

Selections: FEED, CALIBRATION, LENGTH, and NO MOTION

• Feed—feeds the labels to the first registration point.

• Calibration—determines the length of the label and adjusts the

sensor settings.

• Length—In continuous mode, feeds the last stored label length. In

noncontinuous mode, calibrates based on the maximum label length

setting (see Set Maximum Label Length on page 78).

• No Motion—the media does not move. You must press

FEED to

cause the printer to resynch to the start of the next label.

To change the value shown:

1. Press SELECT to select the parameter.

2. Press

PLUS (+) or MINUS (-) to scroll through the options.

3. Press SELECT to accept any changes and deselect the parameter.

Table 9 • Printer Parameters (Page 18 of 23)

Parameter

Action/Explanation

ZPL MODE

- ZPL II +

MEDIA POWER UP

- CALIBRATION +

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 165 166

Keine Kommentare

Zebra Z6Mplus Betriebsanweisung Seite 98