Zebra Z6Mplus Betriebsanweisung PDF herunterladen (Seite 95)

Configuration

Control Panel LCD Displays

1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A

Set Protocol

Protocol is a type of error checking system. Depending on the selection, an

indicator may be sent from the printer to the host computer signifying that

data has been received. Select the protocol that is requested by the host

computer. Further details on protocol can be found in the ZPL II

Programming Guide.

Default: NONE

Selections: NONE, ZEBRA, ACK_NAK

Note • ZEBRA is the same as ACK_NAK, except that ZEBRA

response messages are sequenced. If

ZEBRA is selected, the printer

must use

DTR/DSR for host handshake protocol.

To change the value shown:

1. Press SELECT to select the parameter.

2. Press

PLUS (+) or MINUS (-) to scroll through the options.

3. Press SELECT to accept any changes and deselect the parameter.

Set Network ID

Network ID is used to assign a unique number to a printer. This gives the

host computer the means to address a specific printer. This does not affect

TCP/IP or IPX networks.

Default: 000

Range: 000 to 999

To change the value shown:

1. Press SELECT to select the parameter.

2. Press

MINUS (-) to move to the next digit position.

3. Press PLUS (+) to increase the value of the digit.

4. Press

SELECT to accept any changes and deselect the parameter.

Table 9 • Printer Parameters (Page 15 of 23)

Parameter

Action/Explanation

PROTOCOL

- NONE +

NETWORK ID

- 000 +

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 165 166

Keine Kommentare

Zebra Z6Mplus Betriebsanweisung Seite 95