Zebra ZE500 Betriebsanweisung PDF herunterladen (Seite 59)

Printer Setup and Operation

Connect the Print Engine to a Power Source

8/23/12 P1051584-002

Connect the Print Engine to a Power Source

The AC power cord must have a three-prong female connector on one end that plugs into the

mating AC power connector at the rear of the print engine. If a power cable was not included

with your print engine, refer to

Power Cord Specifications on page 60.

To connect the print engine to a power source, complete these steps:

1. Plug the female end of the A/C power cord into the A/C power connector on the back of

the print engine.

2. Plug the male end of the A/C power cord into an appropriate power outlet.

Caution • For personnel and equipment safety, always use an approved three-conductor

power cord specific to the region or country intended for installation. This cord must use an

IEC 320 female connector and the appropriate region-specific three-conductor grounded

plug configuration.

115 V AC

230 V AC

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 169 170

Keine Kommentare

Zebra ZE500 Betriebsanweisung Seite 59