Zebra ZM400 Betriebsanweisung PDF herunterladen (Seite 101)

101

Hardware Troubleshooting

Troubleshooting the 10/100 PS

02/01/2011 ZebraNet

10/100 Print Server User Guide 47619L-006 Rev. A

4. See Figure 36. You see a reply from the print server indicating a connection.

Figure 36 • Example of a Successful Ping

If the issue is a communication problem, you would have received an error message.

Telnet

Open a telnet session to send a ZPL command from a DOS prompt.

To print a configuration label by sending a ZPL II command, complete these

steps:

1. Open a DOS window.

To open a DOS window, click on

Start > Run.

2. In the Open text box, type: cmd

3. From the DOS prompt, type:

telnet xxx.xxx.xxx.xxx 9100

where xxx.xxx.xxx.xxx is the IP address of the print server.

This will connect your PC to the 10/100 PS through the parallel port of the printer.

4. Enter ~WC.

This ZPL command will print a configuration label on your printer.

5. Click the X in the upper right-hand corner of the window to exit.

If the configuration label prints, the issue is not a communication problem between the printer,

the print server, or the PC.

Note • You do not need to open a telnet session if you pinged the printer using the previous

procedure. The purpose of these two procedures is to identify whether your PC can

communicate with your printer.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 115 116

Keine Kommentare

Zebra ZM400 Betriebsanweisung Seite 101