Zebra ZM400 Betriebsanweisung PDF herunterladen (Seite 31)

Getting Started

Assigning an IP Address with DHCP

02/01/2011 ZebraNet

10/100 Print Server User Guide 47619L-006 Rev. A

Assigning an IP Address with DHCP

Assigning an IP Address via ZebraNet Bridge

ZebraNet Bridge may be used to set the IP address. Refer to the ZebraNet Bridge Enterprise

User Guide for more detailed information.

Assigning an IP address from the Printer LCD

These steps can be used with all printers. However, the liquid crystal display (LCD)

instructions are for printers with a control panel (also known as an LCD).

To assign an IP address from the printer LCD, complete these steps:

1. Turn on (I) the printer and wait until the LCD says PRINTER READY.

2. See Wired Network Parameters on the LCD on page 94 for specific 10/100 PS menu

options or your printer’s user guide for specific instructions on the operation of your

printer.

3. You may edit any of the following network settings in order to communicate with any

10/100 PS in your network environment.

• ip resolution (dynamic, permanent) The printer menu item

IP RESOLUTION

must be set to

PERMANENT if attempting to assign the IP address from the control

panel.

• default gateway (default setting of 000.000.000.000)

• subnet mask (default setting 255.0.0.0)

• ip address (if initial default setting is 0.0.0.0, after 2 minutes this defaults to

192.168.254.254

• ip protocol (gleaning only, RARP, BOOTP, DHCP, DHCP and BOOTP, all)

Important • Your 10/100 PS must have firmware 1.xx.x and higher and your Zebra printer

must have firmware x.10 or higher with an LCD.

Important • To change any of these settings, you need to enter the printer password. The

default password is

1234.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 115 116

Keine Kommentare

Zebra ZM400 Betriebsanweisung Seite 31