Zebra ZM400 Betriebsanweisung PDF herunterladen (Seite 24)

Installation

External 10/100 PS

47619L-006 Rev. A ZebraNet

10/100 Print Server User Guide 02/01/2011

Installation Instructions

To install an external 10/100 PS, complete these steps:

1. Turn off (O) the printer.

2. On the back of the printer, connect the 10/100 PS device to the parallel port.

Figure 4 shows the location and provides an enlarged illustration of the parallel port.

Figure 4 • Rear of 105SL Printer

3. Secure the wire locks.

4. On the back of the 10/100 PS, connect an active Ethernet cable to the RJ-45 connector

Ethernet connector.

5. Turn on (I) the printer.

The 10/100 PS performs a Power On Self-Test (POST). This takes about 45 seconds.

During the POST, the 10/100 PS Status LED (just below the TEST button) turns red and

flashes on and off. Once the POST is successfully completed and the 10/100 PS is fully

initialized, the 10/100 PS Status LED turns green.

For more details on status indicators, see 10/100 PS Status Indicator on page 98.

6. To check the status of the 10/100 PS, press the Test button located on the back of the

10/100 PS.

This prints out a configuration label of the 10/100 PS. To see a sample label, see Figure 5

on page 25.

Note • If there is not an active Ethernet cable attached to the 10/100 PS, the LED indicator

turns red and slowly flashes on and off.

Parallel

Port

Connector

Printer Back

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 115 116

Keine Kommentare

Zebra ZM400 Betriebsanweisung Seite 24