Zebra KR403 Spezifikationen PDF herunterladen (Seite 37)

10/29/2010 Software Integrator Guide P1026208-001 Rev. B

Setting Printer Behaviors

Overview

The ZebraDesigner Windows driver (hereinafter referred to as “driver”) is the primary

method used to make printer configuration changes to the prototype receipt in

development. The driver interacts with the ZebraDesigner (ZD) application to print

receipts. ZebraDesigner provides an optional printing method - print to file. The print file is

ZPL code that can be sent to the development printer or another similarly configured

printer to recreate that prototype receipt.

ZPL printer configuration features can be modified from the default printer settings via the

driver. Changes made in the driver are reflected immediately in the next ZPL print file that

is printed.

The ZPL print file code is broken into two groups (if external fonts and graphics are not

used): Format and Configuration commands that remain constant from print job to print

job, and those Format commands that are needed to print a receipt design (and handle

media) during printing. Most of the Format and Configuration control commands are saved

to the printer in this first print format group of the ZPL print file. Note that some commands

can be part of either group when you begin to program and modify ZPL.

The driver’s primary printer configuration pages (tab windows) are covered here with

references to the ZPL commands. If it does not have a ZPL command associated with it in

ZebraDesigner, then the ZebraDesigner layout control is noted. Each page referenced in

the chapter modifies either the Format and Configuration control commands or the Print

Format commands.

The two driver pages that modify and add to the Format and Configuration control

commands have a simple check box to select the printer settings or use the driver's. A

check box in the top left corner of the pages to ‘Use Printer Settings...’ is on the 'Advanced

Settings' and 'Other' driver pages.

Access the driver from ZebraDesigner by opening the ‘File’ pull-down menu and selecting

‘Printer Settings ...’.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 157 158

Keine Kommentare

Zebra KR403 Spezifikationen Seite 37