Zebra KR403 Spezifikationen PDF herunterladen (Seite 75)

Learning ZPL

Basic ZPL Exercises and Examples

10/29/2010 Software Integrator Guide P1026208-001 Rev. B

Exercise 2 • This exercise shows you how to print a configuration status printout.

1. Send this format to the printer:

2. Save this printout for the next exercise.

Exercise 3 • This exercise shows you how to save a new printer configuration setting.

1. Send this format to the printer:

2. Print a configuration receipt and compare the LABEL LENGTH setting

• You can place additional configuration commands in this type of configuration

format (form) to be saved. Just place them in the format before

^JUS command.

•Use the

^JU command to also Restore Factory Defaults (^JUF) and Recall Last

Setting (

^JUR).

• Note: Use the

^JU command to also Restore Factory Defaults (^JUF) or Recall

Last Setting (

^JUR) at the beginning of a receipt format (form) to place the printer

in a known configuration or simplify the format.

This control (~) command causes the printer to print a Printer

Configuration Label (receipt) immediately. Control commands do not

need the

^XA and ^XZ start and end format (form) commands to

execute.

~WC

Every format starts with the

^XA command

^LL (Label Length) command - Sets the printer to the minimum receipt

length of 70mm or 560 dots

Note: The maximum

^LL is set by ^ML.

^JUS (Configuration Update) command in this instance, save the ALL of

the current configuration settings so the printer can use them after a

power up or reset.

Every format ends with the

^XZ commands

^XA

^LL560

^JUS

^XZ

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 157 158

Keine Kommentare

Zebra KR403 Spezifikationen Seite 75