Zebra KR403 Spezifikationen PDF herunterladen (Seite 45)

Operation

Attaching Power

12/23/2009 KR403 Integrators Guide P1016701-001

Attaching Power

1. Make sure the printer’s power supply is turned off. Or if you are using the optional power

supply accessory shown in the illustration below, make sure the power supply’s AC power

cord is unplugged. Note the printer does not have an integrated power switch.

2. Insert the 24 VDC power supply’s power connector into the printer’s power receptacle.

Verify the power plug’s latch has locked to the connector by giving it a slow gentle pull.

3. Insert the AC power cord into the power supply. Plug the other end of the cord into an

appropriate AC electrical outlet. The active power light will go on if power is on at the AC

outlet.

4. With the power supply on and connected to the printer, the printer’s power status indicator

will light up green. The printer will begin the printer initialization process which takes

approximately 25 seconds. The printer will test the cutter and check for the presence

media. The status indicator will be green if media is loaded and flashing red (single blink)

if media is not loaded.

Caution • Never operate the printer and power supply in an area where they can get wet.

Serious personal injury could result!

Printer Power

Connector

Plug Varies

by Country

Active Power Light

Power

Cord

Printer

Optional Power Supply

Accessory

IEC 60320 C-13 Plug

Note • Ensure the appropriate power cord with a three (3) prong plug and an IEC 60320-C13

connector are used at all times. These power cords must bear the relevant certification mark of

the country in which the product is being used.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

Keine Kommentare

Zebra KR403 Spezifikationen Seite 45