Zebra TTPM3 Spezifikationen PDF herunterladen (Seite 25)

Operation

Error Handling

01/06/2009 TTPM3 Installation and Programming Manual P1003642-001

Error Handling

The blue and green indicators lights up at power ON. If they fail to light up, switch the TTPM3

OFF and ON again. If the indicators are still OFF, check your power connection both in the

TTPM3 and in the wall outlet. Also check your main power supply fuse.

TTPM3 Start-up

The TTPM3 has Flash memory where the firmware and parameter settings are stored. All print

field definitions are stored in RAM and disappears when the printer power is switched OFF.

Power Failure Cleanup

If “Clear ticket path at startup” is enabled (parameter 8), TTPM3 tries to find out if a ticket is

in the ticket path at any other location than at the top of form position at power ON. If it finds

a ticket, it destroys the magnetic encoding, prints VOID on it and outputs the ticket. If the

printer is equipped with a front load 3 unit, the ticket is redirected to the waste bin.

Start-up Synchronization

To enable the TTPM3 to synchronize itself to the incoming data after power up, either after a

usual power ON, or after a power failure, the printer has to receive either a !C command that it

will execute, or a !P command that it will ignore.

Using the !C command to initiate the TTPM3 clears all data that has previously been stored.

To avoid having data cleared, the !P command can be used, for example, to retain document

data stored in the TTPM3 prior to a power failure or power OFF.

Note • Please remember that the TTPM3 has to receive either the !C or !P command, after

power up. All other commands and data will be ignored until !C or !P has been received.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 111 112

Keine Kommentare

Zebra TTPM3 Spezifikationen Seite 25