Zebra TTPM3 Spezifikationen PDF herunterladen (Seite 65)

Programming

Command Reference

01/06/2009 TTPM3 Installation and Programming Manual P1003642-001

Storage Commands

A number of bytes in the flash PROM hold various parameter values called default

parameters. One or several of them can be overridden temporarily with this command.

A space must separate the parameter number and the parameter value

See Default Parameter Settings on page 74.

The permanently stored parameters will be used again after a printer-reset command or at

power ON.

The temporary values can, however, be stored in the flash PROM as permanent values with

command !H S.

Stores the current setting of all parameter values in the setting memory. These parameters are

then used as default parameters. Storing takes approximately 4 seconds. The printer activates

the cutter to indicate that storing is complete.

This command requests information about the setting of parameter n1. The reply is the

parameter value stored in flash PROM or any parameter value temporarily set by other

commands.

The parameter names under Summary of Parameter Settings on page 76.

!H P n1 n2

Set Parameter Value

21 48 20 50 20 n1...n2 hex

33 72 32 80 32 n1...n2 decimal

n1 Parameter number as decimal digit(s)

n2 Parameter value

Example • This example sets parameter 1 (baudrate) to 115200 bps.

!H P 1 11<CR><LF>

!H S

Store current Parameter Values

21 48 20 53 Hex

33 72 32 83 decimal

!S P n1 n2

Parameter-setting data Enquiry

21 53 20 50 20 n1 Hex

33 83 32 80 32 n1 Decimal

n1 Parameter number to start from, as decimal digit(s)

n2 Number of parameters to read out

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 111 112

Keine Kommentare

Zebra TTPM3 Spezifikationen Seite 65