Zebra TTPM3 Spezifikationen PDF herunterladen (Seite 40)

Programming

Command Reference

P1003642-001 TTPM3 Installation and Programming Manual 01/06/2009

Command Reference

The commands in this section are grouped after what they do, and these groups are sorted in a

theoretical usage sequence. It starts with commands for setting up the printer — through

document entry commands — text-and-graphics commands — encoding / reading commands.

Then we end with storage commands that handle the flash memory of the printer.

System Commands

This command takes no parameter. All definitions are cleared. Stored layout is erased.

Subsequent

!C’s are ignored.

The

!C command is also used to initialize TTPM3 after a power ON.

Auto-clear can be used to clear the memory between tickets instead of using

!C. Auto-clear

executes faster than

!C. When auto-clear is enabled any !C commands in the received data will

be ignored, apart from when initiating the printer. Use parameter 57 to enable/disable auto-

clear.

!CA, adding an A to the !C command enables extended acknowledgement.

!C1, adding the digit 1 to the !C command clears the wastebasket counter. See !Y1.

This command triggers both the encoding, printing, cutting and ejecting of a ticket.

Printing follows a successful encoding. The magnetic code and print information, as well as

cut and eject behavior, must first be defined using the applicable commands.

!P is received before a clear all command after power ON, the !P will initiate the printer

without printing a ticket. This means that all data received prior to the

!P will be discarded.

If !P is received and the printer is out of paper, it will give error code NAK P and discard the

received data.

• Eject to Waste Basket

Adding an @ character (

!P@) makes the printer eject the completed ticket into

wastebasket (FL3 printers). One use for this can be to make status printouts that are not

intended for the customer.

• Encoding Retries

Adding a single digit after the

!P makes it possible to set the maximum number of

encoding retries for one ticket. The number given is the number of additional tries i.e.

!P 1

means one normal attempt plus one retry. Default is 1, which is the value used if no digit is

present.

Clear all

21 43 n1 Hex

33 67 n1 decimal

21 50 Hex

33 80 Decimal

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 111 112

Kommentare zu diesen Handbüchern

Keine Kommentare

Zebra TTPM3 Spezifikationen Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucken & Scannen Zebra TTPM3