Zebra RW SERIES Spezifikationen PDF herunterladen (Seite 14)

RMAN-RWS-001 rev. B • Introduction • -1-14 •

RW Series Unit Test & Calibration

Equipment Required

1. A computer with the following minimum conguration:

• Pentium CPU

• 256 MB RAM

• 1.44 MB Floppy Drive

• 1 GB Hard Drive

• CD-ROM drive

• SVGA 14 in.monitor and SVGA card

• 2 Serial Ports

• USB Port

• Windows 95/9, NT or 2000

• Unit Test Software version 3.3 or higher installed with the “euro”

conguration.

2. A bar code scanner, using either RS232 (serial) keyboard “wedge” or USB

communications. (Example: Symbol Model LS1908 series)

3. Serial Interface Cable part number AK18350-1 (or a Zebra approved equivalent).

4. Spare batteries, charger and test media specic to the printer. Refer to the table

in the “Tools and Supplies” topic in Section 2 of this manual.

5. Sensor calibration swatches: p/n AA15417-1 (gray) and p/n AA15417-2 (white)

These swatches are included in Spares Kit AN16753-029C.

Running The Software

CAUTION: DO NOT disconnect the communications cable at any time during the

Unit Test procedure unless prompted to do so by the software!

Certain replacement procedures in this manual will require running the test

procedure to verify a repair. It is recommended that you perform the entire

unit test sequence for these procedures to verify all printer functions after the

replacement.

To Start

• Launch the Unit Test Application.

• Plug the Serial Interface Cable into the printer’s communication port.

• Follow the on-screen instructions.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 113 114

Keine Kommentare

Zebra RW SERIES Spezifikationen Seite 14