Zebra RW SERIES Spezifikationen PDF herunterladen (Seite 19)

• 2-19 • RMAN-RWS-001 rev. B • RW Series Repair Procedures

4. Ensure that the hinge pin is behind the Bar Sense Cable.

5. Peel the backing off the bar sensor cable and adhere it in the groove on the

bottom of the Printer Frame.

6. Install the Printer Frame in the Lower Housing, again referring to procedure for

RK17393-007 if necessary. Avoid putting excess strain on the remaining cables

connected to the CPU Board.

7. Plug the Bar Sensor Cable into J2 (PAPER) on the CPU Board and lock the

connector.

8. Re-install or, if necessary, replace the Platen and Gear Assembly (refer to the

procedure for AK17393-002)

9. Install the Upper Housing, ensuring that you have re-inserted the LCD and

Keypad ex circuits. Also ensure you have re-installed the D-Rings between

the Upper and Lower Housings.

10. Reinstall the battery

11. Calibrate the Sensors.

 Thecalibrationprocedurecanonlybeperformedbycertiedpersonnelusing

special equipment and software.

Using the gray and white swatches, follow the on-screen instructions on

the unit test and set-up software to properly calibrate the sensors. It is

recommended that the complete unit test procedure be performed whenever a

sensor assembly has been replaced.

Peel the adhesive

backing off the Sensor

cable and apply the

Bar Sense Cable into

the groove in the bottom

of the Printer Frame.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 113 114

Keine Kommentare

Zebra RW SERIES Spezifikationen Seite 19