Zebra RW SERIES Spezifikationen PDF herunterladen (Seite 94)

RMAN-RWS-001 rev. B • RW Series Repair Procedures • 2-94 •

Remove the Radio Assembly

You must replace the Radio Assembly you have removed with one of the same type in order

for the printer’s regulatory markings to remain in conformance.

1. Remove the Radio PCB from the Radio Bracket by removing and retaining (2)

screws.

If your printer has a MCR/SmartCard option installed, unplug the two cables

from the Card Reader Assembly to the Radio PCB

2. If your printer has a Bluetooth radio (RK17949-013), detach the antenna card

from the upper housing.

Use tweezers and isopropyl alcohol to loosen the Antenna card from the upper

housing.

3. Remove the Radio Bracket by removing the screws securing the Bracket to the

Upper Housing. The Radio Bracket is secured with (4) screws on Printers with

the MCR/SmartCard option and with (2) Screws on printers without that option.

3. If the printer has an 802.11b radio option, remove the antenna card from the

pocket in the Radio Bracket.

Radio Assembly. (Retain

mounting screws)

If a MCR/SmartCard is

installed, un-plug the two

cables into J2 and J4 on the

Radio Assembly.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 113 114

Keine Kommentare

Zebra RW SERIES Spezifikationen Seite 94