Zebra RW SERIES Spezifikationen PDF herunterladen (Seite 72)

RMAN-RWS-001 rev. B • RW Series Repair Procedures • 2-72 •

Remove the Media Support Disks

1. Turn off the unit, open the Media Cover and remove any media loaded in the

printer. (Refer to User’s Manual.)

2. Remove the existing Support Disks by removing the screw and at washer

securing them to the Media Supports.

Install new Media Support Disks

1. Determine which media core size you will be using. The media core width is

set by ipping the media disks so that the supports for the desired core size

faces towards the inside of the printer. The printer is adjusted at the factory for

media with a 3/4” core.

Printers using media with a 1 3/8” core must have the Media Disks adjusted to

use this media. See “Changing the Media Core Size” below.

Note: Both Support Disks must be set to use the same diameter core.

2. Assemble the Disks. Hold the Support Disk against the Media Support and

secure with the Flat Washer and the Screw as shown above. Ensure the Disk

spins freely after assembly.

3. Repeat this procedure for the opposite side.

Replacement Kit RK17393-004- RW Series Media Disk

Installation Instructions

This kit includes the parts and documentation necessary to install the RK17393-004

Kit Repair RW Series Media Disk in RW series printers. Read these instructions

thoroughly before attempting to install this kit.

Reference Materials

UMAN-RWS RW Series Users’ Guide

Tools Required

#0 or #1 Phillips Head Screw Driver

Cautions

 Caution•Thisinstallationmustbeperformedonlybyaqualiedservicetechnician.

Unless otherwise specied:

• Always turn the printer off

• Remove media before installing this Replacement Kit

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 113 114

Keine Kommentare

Zebra RW SERIES Spezifikationen Seite 72