Zebra Z6M Spezifikationen PDF herunterladen (Seite 100)

Page 4-40 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

3. Refer to the detail in Figure 4-31 and fold the flat end on the new ground cable shiny

side to shiny side.

4. Install the previously removed screw through the washer and ground strap. Tighten

the screw to snug in the new front panel.

5. Check the wiring routing. Use cable ties as necessary to bundle and secure wires. To

prevent electronic noise, ensure the ribbon cable is in the clips on the bottom of the

printer. Keep the narrow ribbon cable from the control panel away from the wide

ribbon cable.

6. Refer to Figure 4-15. Reinstall the electronics cover. Align the rear surface of the

cover with the rear surface of the main frame. Secure with fasteners from the media

side of the printer.

7. Reconnect the AC power cord to printer. Turn the printer On (l).

8. Set up the front panel according to the previously printed configuration label. Print a

configuration label using the Cancel Key Self Test. Compare results and adjust as

necessary.

9. If a configuration label could not be printed before removing the old front panel,

perform the label quality procedure in your User Guide.

5HSODFH'DQFHU$VVHPEO\

5HPRYH'DQFHU$VVHPEO\

1. Turn the printer Off (O) and disconnect the AC power cord.

2. Refer to Figure 4-15. Open the media door and remove all media and ribbon from

the printer.

3. Refer to Figure 4-32. Relieve the spring tension from the dancer assembly by using

a long nose pliers and moving the torsion spring leg off the printer post.

4. Remove the E-ring, then slide off the bearings, the dancer, and the torsion spring.

Note • Use caution when securing the front panel that the ground cable does

rotate more than 1/8 turn.

Caution • Wear protective eyewear when removing E-rings, C-clips, snap rings, and

springs. These are under tension and could fly off while removing.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 100