Zebra Z6M Spezifikationen PDF herunterladen (Seite 134)

Page 4-74 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

,QVWDOODWLRQRI5HZLQG3DQ

1. Refer to Figure 4-71. Place the main frame onto the rewind pan assembly. Ensure

the rear ledge of the main frame rests completely on the rear support in the pan.

Figure 4-71. Rewind Pan Installation

2. Install, but do not tighten, the main frame mounting screws provided in the kit. After

starting the screws, recheck the alignment from step 1, tighten the two screws on the

rear of the main frame.

3. Tighten the rest of the main frame mounting screws.

4. Reinstall the rear cover by sliding it under the screw loosened previously on the

main frame. Leave the screw loose.

5. Using the two screws and washers supplied in the kit attach the rear cover to the

rewind pan. Tighten the two screws and the one screw on the main frame.

6. Connect the rewind cable assembly to the connector on the rewind motor and

spindle assembly.

Note • Alignment is very important. The platen housing leg must be inside the

mounting tab of the rewind pan.

Main Frame

Mounting Screws

Main Frame

Mounting Screws

Rear Cover

Mounting Screws

Platen Housing

Mounting Screw

Rear

Cover

rame

Rewind Pan

Assembly

Main Frame

Mounting Screws

Note • The oversize mounting hole in the pan allows for adjustment of the front

of the pan to align with the door.

Note • Make sure the two holes on rewind support bracket face up and are in-

line with the printer main frame.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 134