Zebra Z6M Spezifikationen PDF herunterladen (Seite 88)

Page 4-28 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

8. Locate the circular cut-out on the top of the outer spring clip, insert a screwdriver,

gently pry up and remove the clip. Use the same procedure for the clip on the

inboard side of the platen roller to loosen the clip.

Figure 4-23. Platen Roller Disassembly

9. Remove and discard the platen roller and bearings.

Install Platen Roller

1. If you removed the old inboard spring clip insert a new spring clip part way into the

inboard platen housing.

2. Refer to Figure 4-23. Install the inboard bearing on to the inboard shaft of the platen

roller as shown.

3. Insert the platen roller shaft through the inboard clip. Start the new inboard bearing

into the clip. Work the inboard bearing back and forth until the bearing is up against

the clip. The round side of the bearing goes down into the housing.

Circular

Cut-Out

Barbed

Legs

Note • The flat side of the bearing must face up.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 88