Zebra Z6M Spezifikationen PDF herunterladen (Seite 83)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-23

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

Figure 4-17. Latch Kit Parts

7. Using a small punch, very lightly tap the spring pin from the rear of the platen

housing until it is free from the latch and can be removed.

8. Remove the latch and compression spring.

,QVWDOO/DWFK.LW

1. Refer to Figure 4-17. Install the compression spring on platen housing post.

2. Align latch with spring pin holes. Insert the spring pin through the front hole of the

latch and though the platen housing. The rear hole in the latch is the only small one

and you will need to tap on the spring pin. Lightly tap the spring pin into the rear

hole. Leave equal amounts of spring pin sticking out on each side of latch.

3. Install the strike plate partially into print mechanism by sliding the short side to the

inside of print mechanism as seen in Figure 4-18.

Strike Plate

Cap

Strike

Plate

Strike Plate

Mounting

Screws

Latch Cover

Latch

Spring

Adjustment

Screw

Mechanism

Platen

Housing

Ribbon Guide

Plate

Front Edge

Washer

Note • The spring pin must be tapped out from the rear and removed from the

front of the platen housing. Trying to remove the pin in the other direction will

damage the platen housing.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 83