Zebra Z6M Spezifikationen PDF herunterladen (Seite 34)

Page 2-8 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 2SHUDWLRQV2YHUYLHZ

Value Peel-Off Mode

(Value peel option required)

Refer to Figure 2-5.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

3. Slide out the media guide as far from the printer frame as possible.

4. Place the roll of media on the media supply hanger.

5. Flip up the media supply guide. Slide in the media supply guide so that it just

touches, but does not restrict, the edge of the roll.

6. Feed the media under the dancer, through the slot in the transmissive sensor, and

under the ribbon sensor.

7. Pull approximately 6” (305 mm) of media through the front of the printer.

8. Ensure that the media is against the transmissive sensor. Then, slide in the media

guide so that it just touches, but does not restrict, the edge of the roll.

9. Pull lever to open the pivot bracket assembly.

10. Feed the media through the slot in the peel assembly.

11. Close the printhead assembly.

12. Close the pivot bracket assembly.

13. Peeling will automatically start. Press the FEED key to test.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 34