Zebra Z6M Spezifikationen PDF herunterladen (Seite 43)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 2-17

2SHUDWLRQV2YHUYLHZ 6HFWLRQ

3. Loosen the thumbscrew, slide the rewind media guide to the end of the take-up

spindle and flip the media guide horizontal.

4. Slide the core and liner material from the take-up spindle.

Power Rewind Mode

Refer to Figure 2-11.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

3. Slide out the media supply guide as far from the printer frame as possible.

4. Place the roll of media on the media supply hanger.

5. Flip up the media supply guide. Slide in the media supply guide so that it just

touches, but does not restrict, the edge of the roll.

6. Feed the media under the dancer, through the slot in the transmissive sensor, and

under the ribbon sensor.

7. Pull approximately 36” (1 m) of media through the front of the printer.

8. Ensure that the media is against the back of the transmissive sensor. Then, slide in

the media guide so that it just touches, but does not restrict, the edge of the media.

9. Feed the media over the front housing assembly, through the rewind base, and under

the media alignment spindle.

10. Loosen the thumbscrew and slide out the rewind media guide to the end of the take-

up spindle.

11. Wrap the media around a core placed on the take-up spindle; then, turn the take-up

spindle counterclockwise to wind up the excess material.

12. Slide the rewind media guide against the media, and tighten the thumbscrew to lock

it into position.

13. Close the printhead assembly.

Note • Power peel-off option required. (Being replaced with value peel/rewind

option).

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 43