Zebra Z6M Spezifikationen PDF herunterladen (Seite 67)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-7

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

Figure 4-1. Printhead, Platen Roller and Sensor Cleaning

&OHDQLQJWKH6HQVRUV

Refer to Figure 4-1. Open the media door. Brush or vacuum any accumulated paper lint

and dust away from the printer sensors. The reflective sensor, transmissive sensor, and

ribbon sensor should be cleaned on a regular basis to ensure proper operation of the

printer. For printers with the value peel and power peel option installed, clean the take

label sensor and reflective surface on power peel. Close the media door.

&OHDQLQJWKH9DOXH3HHO0RGXOH

(Value peel option required)

Refer to Figure 4-2. Perform the following procedure if adhesive buildup begins to affect

peel-off performance.

1. Open media door. Open the printhead assembly.

2. Open the pivot bracket assembly by pivoting the module toward you.

3. Use a swab soaked with the Zebra-recommended solvent to remove adhesive from

the tear/peel bar.

Printhead

Transmissive

Sensor

Reflective

Sensor

Ribbon

Sensor

Take Label

Sensor

Platen Roller

Note • Ensure printhead is in the fully upright position and latched.

Note • Do not push down in the middle of the tear/peel bar, it may bend.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 67