Zebra Z6M Spezifikationen PDF herunterladen (Seite 106)

Page 4-46 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

,QVWDOO7UDQVPLVVLYH6HQVRU

1. Feed the sensor cable through the opening under the printhead assembly as shown in

Figure 4-37.

2. Install the sensor to the main frame. Make sure the guide pin of the sensor body

seats in the lower hole for proper positioning.

3. Refer to Figure 4-36. Locate (P5) connection on the main PC board and plug in the

transmissive sensor assembly connector. Route the cable as shown and secure it to

the main logic board bracket using the cable tie supplied in the kit.

4. Secure the transmissive sensor assembly with the mounting screw.

5. Reinstall the gear, making sure the gears mesh properly.

6. Loosely reinstall the stepper motor using the pivot screw, locking screw and

adjustment nut.

7. While lifting up on the stepper motor, reinstall the drive belt. Release the stepper

motor to provide tension on the belt.

8. Make sure belt tension is correct and tighten the locking screw to secure the motor.

Tighten the pivot screw.

9. Replace the electronics cover. Place media and ribbon back into the printer. Close

the media door. Reconnect the AC power cord.

10. Turn the printer On (l) and follow the “Selecting the Media Sensor” instructions in

the User Guide.

Note • Do not overtighten the mounting screw. Damage to the transmissive

assembly housing can occur by overtightening the mounting screw.

Note • Belt deflection should be no more than ¼ inch (6 mm).

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 106