Zebra Z6M Spezifikationen PDF herunterladen (Seite 41)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 2-15

2SHUDWLRQV2YHUYLHZ 6HFWLRQ

Value Peel Rewind Media Alignment

Perform the following adjustment if the media does not track properly onto the take-up

spindle.

1. Refer to Figure 2-9. Turn the adjustment dial clockwise to align the media/liner

material toward the inboard (i.e., main frame or electronics) side. This is the most

likely adjustment.

2. Turn the dial counterclockwise to align the media/liner material toward the outboard

side (i.e., away from the main frame or electronics side).

Figure 2-9. Value Peel Rewind Media Adjustment

Power Peel-off Mode

Refer to Figure 2-10.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

3. Slide out the media supply guide as far from the printer frame as possible.

4. Place the roll of media on the media supply hanger.

5. Flip up the media supply guide. Slide in the media supply guide so that it just

touches, but does not restrict, the edge of the roll.

6. Feed the media under the dancer, through the slot in the transmissive sensor, and

under the ribbon sensor.

7. Pull approximately 36” (1 m) of media through the front of the printer.

Note • The media/liner should be installed flush against the back plate of the

take-up spindle to prevent the media/liner from winding too loosely.

Printhead

Assembly

Adjustment

Dial

Take-up

Spindle

Backplate

Note • Power peel-off option required. (Being replaced with value peel/rewind

option).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 41