Zebra Z6M Spezifikationen PDF herunterladen (Seite 48)

Page 2-22 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 2SHUDWLRQV2YHUYLHZ

$OLJQ6HQVRUV

7UDQVPLVVLYH6HQVRU

There is no positioning of the transmissive sensor. All media is to be loaded through the

transmissive sensor as described in the media and ribbon loading chapters.

6HOHFWLQJWKH0HGLD6HQVRU

A Z4M/Z6M printer can be configured to select either of the sensors. By default the printer

is set to AUTO SELECT during auto-calibration.

The SENSOR SELECT setting may also be changed via ZPL II

. The format for the ^JS

instruction is as follows:

^JSx

Where

^JS=Sensor Select

x=Type of sensor

A=Auto Select

R=Reflective Sensor

T=Transmissive Sensor

The sensor can be selected from the LCD menu (see User’s Guide).

Note • Placing an empty 3” core on the hanger will assist the media movement.

Note • The transmissive sensor should not be used when the sensor type is

set to MARK. If the transmissive sensor is the active sensor when the sensor

type is changed from WEB to MARK, an auto-calibration is initiated to make the

reflective sensor active.

The transmissive sensor should not be used when the media type is set to

Continuous. If the transmissive sensor is the active sensor when the media

type is changed from Noncontinuous to Continuous, and auto-calibration is

initiated to make the reflective sensor active.

Note • Changing the SENSOR SELECT setting via the front panel will initiate

an auto-calibration.

Note • Changing the SENSOR SELECT setting via ZPL II will initiate an

auto-calibration.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 167 168

Keine Kommentare

Zebra Z6M Spezifikationen Seite 48